The electrical supply requirements for your Hot Tub or Swim Spa

Electrical Supply

All spas require a separate circuit up to 45amps single phase. Some spas require a 15amp or 32 amp circuit. Please ask your sales representative regarding requirements.                 

You must arrange for the electrician to install all of the power supply prior to our arrival to site, just leaving a three metre "tail" of excess cable next to the intended location of the hot tub.

When we arrive to site, we position the hot tub to your requirements, and after some quick checks, we can start to fill the tub. Once filling commences, your electrician must pull the "tail" of cable through an entry point into the hot tub's cabinet and make the final connection inside  - we advise that you refer them to this guide.

If for any reason whatsoever, the electrical supply is incomplete on our arrival for handover; we will be unable to fulfill the handover procedure, or demonstrate the operation of the hot tub to you.  We cannot connect to or modify the electrical connection in any way, so you must ensure your electrician completes the work before we arrive.

 

All new circuits should have an approved RCD (Earth Leakage Breaker) fitted by a qualified Electrician.